500amp Warrior Edge DX water cooled pulse MIG welder for hire
TO HIRE EDGE 500 @ £250 p/week
Email us to set an account up and hire straight away.
The ultimate pulse / twin pulse MIG, with extraordinary MIG processes to tackle every material, any thickness, every setup, and every situation.
We recommend using pulse for all materials. It’s clean, fast, spatter free.
NOTE. All Warrior Edge pulsed welders we sell come with the latest LP14 2026 USB updates! These are done in our workshop. The ESAB engineers are continually improving all processes and settings, making this a future-proofed and adaptive evolving machine.
The Arc Dynamics feature is staggering. This is an additional pulse control setting that allows the operator to fine tune the physics of the pulse rate. By turning it up and down it alters the weld aesthetic when welding different materials, to maximise cleanliness, reduced heat, speed, and penetration.
NOTE. Arc Dynamics is set in the middle @ ‘0’ as standard (this is a nice place to start)
When turning up arc dynamics (+1 to +9 maximum), this increase the pulse, and gets a cleaner faster weld. You may have to increase the ‘trim’ (extra wire feed) by small increments (0.1) to accommodate the increased pulse speed. The trade off to increasing AD is that there is slightly less penetration / fusion, due to reduced heat input. This usually isn’t a problem though, as penetration is still present.
When turning down arc dynamics (-1 to -9 maximum), this decreases the pulse, and gets a deeper weld with more penetration. Pulse is still present and extracting the heat input / keeping spatter to a minimum, but is good for thicker materials, ensuring all welds pass.
The Warrior Edge DX is the best pulsed MIG welder in the world… by far. We have the UK’s largest rental fleet of the Edge DX in stock, and have never seen results as good when using the pulsed settings on stainless and aluminium.
If you’re needing to weld pipe, then hire our Edge DX with ROOT process.ROOT weld mode is beyond words and bizarre to witness, as it can bridge across gaps up 30mm wide with perfect side wall penetration at the back.
Spectrum will help you get dialed in straight away with the exact Arc Dynamic, volts, amps, and trim settings for any and every material you’re wanting to weld, to the highest standard imaginable.
NOTE. Always perform a quick 5 second ‘TRUEARC compensate‘ (done from the digital feeder menu) on the steel before welding. You do this if changing torch, position of wire feeder and interlink cable, or adjusting earth lead cable / cable length. This is an auto calibration inductance reset, that super tunes the Warrior Edge cable resistance feedback, to achieve the best synergic settings.
